Date:         Sun, 26 May 2002 12:17:35 -0500
Reply-To:     "Terry K." <CTONLINE@WEBTV.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Terry K." <CTONLINE@WEBTV.NET>
Subject:      Re: Windshield washers
Comments: To: Stan Wilder <wilden1@juno.com>
Comments: cc: wilden1@juno.com
In-Reply-To:  Stan Wilder <wilden1@juno.com>'s message of Sun, 26 May 2002
              10:10:35 -0500
Content-Type: Text/Plain; Charset=US-ASCII

Stanley--you are from Warsaw--

You don't have to remove the whole dash to do this update----

I simply drilled out the orifice of the current squirter's to accept a
small copper tube, inserted the tube, attached the hose for the arm
mounted nozzle's, and PTL, and Hallelujah--I had arm mounted, mobile
washer nozzles---

No big deal----


Later,

TK---


E-mail message


I really hate to think about pulling that whole dash panel out to get to
the current squirters.
Got any short cuts that make the conversion easier. I've seen a lot of
*right on the wiper arm squirters* and I think you're onto something
there.
Probably fix the wiper blade problem too.
Stan
On Sun, 26 May 2002 09:55:51 -0500 (CDT) CTONLINE@webtv.net (Terry K.)
writes:
Stan,
I removed the spray nozzles and fitted Mack truck clip on spray heads on
the end of the wiper arm--it's a clip on affair---
So when the washer is activated, I get a spray right where it should
be---direct in the path of the wiper blade-----not to the right, not