VERY good point! Sorry, its been a while since I did one. I would also recommend generously applying grease to the tap before you use it - this will catch the majority of the chips. Z --- JKrevnov@aol.com wrote: > > In a message dated 5/31/02 8:04:15 AM, > zmaninco@YAHOO.COM writes: > > << Make sure the piston is down. > Drill the hole. > Tap it. > Use a blow with an extension tip - extend it into > the > chamber and blow out all of the chips. (VERY > CRITICAL) > Install heli-coil, keen-sert, whatever you use. > Install new plug. > >> > > To prevent the cuttings from getting into the > cylinder, open the inlet valve > and apply shop air to the intake. Back out the tap > frequently. Also, for > all I know, a spiral tap with an up twist may be > available. > > Rich >
__________________________________________________ Do You Yahoo!? Yahoo! - Official partner of 2002 FIFA World Cup http://fifaworldcup.yahoo.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.