Well, the good news is that the head is finally off. The bad news is, the cylinder sleeves seem to be pretty far out of their home position... I'd say about two inches. I tried using moderate force to slide them back in, but they don't want to go. Should I use the "AMF" method (apply more force)? Or am I in deep doo doo at this point? Can someone please take a peak at the photo on the bottom of the following page linked below and let me know their opinion? Thanks in advance (TIA) Dave in KC 85 Westy |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.