Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2002, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 4 Jun 2002 22:53:04 -0500
Reply-To:     "Terry K." <CTONLINE@WEBTV.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Terry K." <CTONLINE@WEBTV.NET>
Subject:      Re: A/C Advice Needed -- Kind of Long
Comments: To: Ray Reinhard <rayreinhard@SBCGLOBAL.NET>
In-Reply-To:  Ray Reinhard <rayreinhard@SBCGLOBAL.NET>'s message of Tue, 4 Jun
              2002 16:37:56 -0700
Content-Type: Text/Plain; Charset=ISO-8859-1

Ray,

I think it's about time you buy yourself an AC book from your local Snap on dealer, and start reading----

$2400.00 dollars for basicly nothing is what I'm reading here----

AC is not complicated, or difficult to maintain or repair---just a little common sense and the time to do it is all thats required---

You could get most of all the tools required to perform all the stuff these guys did, for a mere pittance of what they charged you the first time--and are trying to charge you again--- Ebay is the place to look for some good deals on AC stuff---

This is borderline to insanity to even think of returning to the Bendover Bros. AC repair facility---

Later,

Terry

E-mail message

Ever since we bought our van in 1990, we have had problems keeping the A/C running well. From 1990 to 1999, we took the van to a leading independent A/C repair shop in Sacramento, spending a total of over $2,400 over this period. Components repaired and/or replaced included the drier, condenser, and compressor (the latter was replaced in July 1999). In August '99, we moved to the Santa Cruz area and, in September 2001, had a TiiCo engine installed. Unfortunately, the A/C hoses were not quite long enough to reach to the compressor in its new position, so I had to make another trip to Sacramento (and spend another $500+) to get this fixed in November 2001. At the end of the day, the A/C still wasn't working properly, so the technician said to bring it back and not use it in the meantime. Not needing A/C during the winter, we returned in March and spent another $250 to have the A/C wired up to the engine fan. On leaving the A/C shop, I immediately noticed a very strong front-end vibration when I tried to use the A/C but it was too late to do anything more as I had to get back to Santa Cruz. At least the A/C seemed to be cooling properly. (Subsequent inquiries to this list suggested that the A/C tech had wired the fan to come on in the "high" position immediately --a fact I later confirmed.) I didn't have much occasion to use the A/C in the next couple of months -- just turning it on from time to time to see if the vibration was as bad as I had remembered it (it was!). Then, one day I turned it on and the vibration stopped! There still seemed to be cold air coming out of the A/C vents, so I thought (ha, ha) maybe the fan problem had fixed itself. In May, we were driving on a warm day and it was clear that the A/C was NOT cooling properly. Air was blowing out of the vents in the rear of the van, but it was not cold. So, last Friday, I returned to Sacramento to once again try to get things fixed. On the way, I had the A/C fan switched on to at least get some air circulation. I was just north of Stockton when the dash warning lights came on. I stopped the van, opened the engine compartment, and found smoke pouring out of the A/C compressor. The repair shop admits that they wired the engine cooling fan to start in the "high" position whenever the A/C was switched on. (They defend this as "good practice" in an area that gets as hot as Sacramento.) We also now know that, when the vibration stopped, it was because a 30 amp fuse protecting the fan had blown. The A/C tech says that he tested the amperage draw last Friday and that the fan normally draws 24 amps -- but when it is first turned on it "spikes" at 60 amps. I don't know for sure, but I suspect that this is related to having the fan come on immediately on "high," as this fuse never blew before during our 12 years of owning the van. The manager is proposing to repair things "at cost" and thinks that I should also replace the fan. (I checked w/ Camelback VW and a replacement fan runs $550+.)   I think that the repair shop should replace my compressor and anything else that burned out at no charge; wire the fan to come on "low" (and then go to "high" if needed); and forget about a new fan. Your thoughts, comments, suggestions would be GREATLY appreciated. Ray Reinhard '86 Tiico Westy Camper GL


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.