Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2002, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 7 Jun 2002 06:16:51 -0700
Reply-To:     "Thomas D. Hanlon" <hanran@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Thomas D. Hanlon" <hanran@EARTHLINK.NET>
Subject:      Selector Shaft Bushing installation
Content-Type: text/plain; charset=us-ascii

Listees,

Is is possible to replace both the selector shaft bushing and the selector shaft oil seal with the transmission installed? Bentley (35.15) is unclear to me on the bushing method, though it is clear to me that the bushing can be installed, "in van."

The "wobbly" selector shaft seems to be seated, "better" with the seal pressed in.

Thanks.

Tom Hanlon Palm Springs, CA 84 Westfalia


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.