In a message dated 6/12/02 9:24:30 PM, thewestyman@MINDSPRING.COM writes: << These, I repair by carefully machining little collars to clamp over the shoulder of both sides of the plastic gear. >> You must have a Rivett 608 and not care about a profit. Clamping rings which are a proper force fit on the hubs of the wormgear of a VDO odometer can be cut from the miniature brass tubing found in most hobby shops. If memory serves me right, 1/4" X 0.031 is the size which works, but check the sizing first. Rich |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.