Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2002, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 17 Jun 2002 08:42:03 -0700
Reply-To:     mark drillock <drillock@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         mark drillock <drillock@EARTHLINK.NET>
Subject:      Re: RE : sink pump mystery - 1981 westy
Comments: To: Steve Selin <sjselin@NETZERO.NET>
Content-Type: text/plain; charset=us-ascii

See the posts regarding the LED panel. You may have the older 80/81 panel with an extra feature to prevent the pump from burning out by being run with an empty tank. If you have 2 red LEDs at the bottom of the left row then this is the case. Later models have green at the bottom and 1 red just above the green.

You can easily override the pump voltage cutoff circuit with a little soldering. Is this something you can and wish to do? I did this when I installed an early type panel in my 87.

Mark

Steve Selin wrote: > > Thanks. That one is fine too. It is about 3 inches from the pump. > > That fuse is not getting any juice. > > Steve > > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]On Behalf > Of mark drillock > Sent: Sunday, June 16, 2002 10:58 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Re: sink pump mystery - 1981 westy > > Early Westy models had the external pump mounted under the sink. These > models had a separate inline fuse holder adjacent to the pump. It is a > black tube with wire coming out of each end. > > Mark > > Steve Selin wrote: > > > > Hello, > > > > My sink pump works and the switch at the faucet works BUT the pump does no > > go on when the switch is activated. > > > > All fuses look good. I checked, and there is no juice getting to the > pump. > > Looking at the fuses by the driver door pillar there are 2 that are > separate > > from the rest. All fuses look good. > > > > I looked under the driver seat and found a fuse (16) that is good. There > is > > another wire in there that gets 2-3 volts when the key is in the ON > > position. > > > > Any idea where the juice is for my pump? > > > > Thanks, > > Steve > > > > _*_*_*_*_*_*_*_*_*_*_*_*_*_*_*_*_*_*_*_*_ > > > > Steven Selin - s.j.selin@vt.edu


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.