Date: Fri, 21 Jun 2002 19:49:44 -0500
Reply-To: John Rodgers <j_rodgers@CHARTER.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: John Rodgers <j_rodgers@CHARTER.NET>
Subject: Re: 87 Westy Trouble Starting in Cold
Content-Type: text/plain; charset=us-ascii
John, I have just been through a bunch of similar hassles. Here's what I did.
I looked around AND moved around various hoses on and over the engine. I found a
vacumn line was off it's connection. Reconnected it. I also discovered the
crankcase vent line had rotted, so what ever pressures - positive or negative -
were supposed to be maintained in the crankcase weren't. Replaced it. Engine
smoothed out considerably. Additionally, after warming the engine thoroughly, I
disconnected the idle stabilizer valve, and adjusted the idle speed to 900 rpm.
I also cleaned the ISV with carburetor cleaner. Reconnected all for a cold
start. it started easily, idled easily and smoothly. Went for a drive, and the
engine bucked a bit, especially at partial - like feather footing the throttle -
throttle settings. even bucked a bit whe of throttle completely. Disconnected
the ISV and drove again. Smooth as silk. Obviously a problem with the ISV or the
ISC (idle stabilizer control - right side behind the tail-light assembly.
This I have not resolved yet. So on a cold start, I to have to keep a little
throttle on it to keep it idling until warm. If I start of too soon the engine
tries to bog down or stall. Just typical cold engine without the benefit of any
cold start fuel supply.( read "enriched" with extra fuel.)
I would give this a go before doing anything else. If you still have a problem,
I would be suspicious of the Temp II sensor.that mounts by the thermostat jus
forward and to the left of the engine.
Good luck.
John Rodgers
88 GL Driver
"John W. Parkins" wrote:
> Hi all,
> First of all, yes, I have searched the archives regarding this problem. I
> have found some good advice, but nothing that has worked.
>
> In cold weather I have trouble starting the Westy. The only way it will
> start is to floor the accelerator and hold it there (taken from an archive
> suggestion; it works). Once it starts, it chugs for a while, maybe five
> seconds of so. Meanwhile, I'm still holding down the accelerator. Then
> something seems to kick in and the engine races. At that time, of course, I
> let off the accelerator and everything is fine, though the engine still runs
> a little rough. Once I start it in the morning, it's easy to start later in
> the day. It is as if a valve is sticking, and once it breaks free,
> everthing is fine.
>
> I've replaced the rotor, distributor cap, and spark plug wires (they were
> due anyway). I know others have had this problem. One person had to
> replace the computer (please say it ain't this). Another person suggested a
> vacuum leak. Any other ideas from you folks? Responses are greatly
> appreciated.
>
> Cheers,
> John
|