Date: Fri, 28 Jun 2002 10:31:12 -0500
Reply-To: wilden1@JUNO.COM
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Stan Wilder <wilden1@JUNO.COM>
Subject: Re: Aux Oil Cooler install...results Aircooled vanagon
Content-Type: text/plain; charset=us-ascii
Glad to see that you decided to install the cooler.
Now, And i drove ti hard yesterday, my oil temp is around 90-95C,
> heads 275-325, and oil is up about 5-10 lbs...........is this
> awesome or what? Definitely one of the best mechanical things I
> have done to my van.
----------------------- Clip --------------------------
Here is a little test for you: Run your engine normally for about an hour
at the speeds you want to be driving at. Pull over and park your van on a
steep incline or with the drivers side wheels up on a curb.
Take a candy thermometer and drop it into your oil fill tube. Give it
about two minutes to register and check it against your oil temperature
gauge. (need the oil table up into the filler tube).
Since Candy goes crazy with + or - 5 degrees (f) these thermometers are
very accurate for the cheap price. (mostly less than $4.00).
The VDO gauges are *averaging the temp* that you read on your gauge. It
takes a long time to go up and about the same to go down.
My VDO oil temp gauge may say 100 (c) and if I want it to read something
else I just put in another of the same gauges and I'll have a different
reading, speaks volumes about their quality.
In addition the placement of the sender can give you various results. At
the sump plate location you are reading the temp of the oil that is being
bypassed back into the crank case after use by the engine bearings.
To farther confuse you the power supply for your gauge needs to be
powered from a terminal that has its feed from the voltage stabilizer.
(example: If you've got a Volt meter, the needle shouldn't bounce when
the flashers are on. If they do, you've got the wrong power source.)
An additional direct ground from the engine case to your ground multi pin
connector behind your dash will also bring more accuracy.
Summary: Don't quit working until you match the gauge to the candy
thermometer or you're just guessing at the oil temp.
CHT changes are almost immediate within one minute but I can change my
CHT by swapping gauges too.
If you added length to the CHT installation kit wires, its unlikely that
you got the exact copper alloy in both the VDO kit wires and your
extension wires, hence you're once again guessing.
I don't know of a fix for this but I found that giving the wires a good
insulation wrap at the solder joints keeps the joints from becoming mini
senders that effect your gauge reading.
I've done all the things I've suggested and I'm exhausted from *lack of
proper instructions*.
Stan Wilder
83 Air Cooled Westfalia
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit:
http://dl.www.juno.com/get/web/.
|