In a message dated 6/26/02 4:22:31 PM Pacific Daylight Time, jbrschawn@EARTHLINK.NET writes: << I'm in the middle of replacing my GL middle seats with a Carat (table). Can someone please answer a few questions on this conversion. Like: 1) do you have to cut the upper body area for the table frame and bend it back or cut it off?>> Just bend it back. << 2) is there an extension for the bench seat mounting post on the driver's side? >> The rear bench requires four (4) mounting blocks. Two on the top and two on the bottom. These allow the narrower bench to clear the plastic side panels. BenT <A HREF="http://hometown.aol.com/bentbtstr8/myhomepage/index.html">Vanagon Cafe</A> |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.