Hi amigos: A few days ago, I took all rear and front suspension in order to correct that left limp that happens to all our westies. I found a rubber disc on top of springs which, I supposed, was to level the van. I noticed that they were taller than the half inch i needed to add so, instead of adding I proceeded to cut that measure from the disc. After cutting the right hand disk I thought the van would be leveled but it has the same left syndrome; nothing changed. My question is: How do I measure the gap from tires, height or whatever, in order to calculate the seize of disc I have to add (never cut again). TIA
Javier |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.