Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2002, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 25 Jun 2002 22:35:26 -0700
Reply-To:     Tobin Copley <tobin.copley@UBC.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Tobin Copley <tobin.copley@UBC.CA>
Subject:      Re: Wiring/testing of VDO oil pressure gauge (dual sender)
Comments: To: kdlewis@juno.com
In-Reply-To:  <20020625.185001.-466949.0.kdlewis@juno.com>
Content-Type: text/plain; charset=US-ASCII; format=flowed

On Tuesday, June 25, 2002, at 02:57 PM, kdlewis@juno.com wrote: > Tobin; > Did you remove the wire from the sender or the gauge? If you > remove the wire from the sender then it is shorted somewhere along it's > route. >

Ken, I thought of that. First tried removing the wire at the sender, then from the gauge. Same difference--gauge needle stays rock solid at "0".

:-/

T.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.