Date:         Wed, 26 Jun 2002 14:55:57 EDT
Reply-To:     Oxroad@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jeffrey R <Oxroad@AOL.COM>
Subject:      WTB syncro.org 2WD spring shims
Content-Type: text/plain; charset="US-ASCII"

I finally installed the 2WD springs from Steve at Syncro.org.

It's too soon for a full report, but the bus does seem to ride much better.

I want to compensate for the 1/2 inch lower driver's side that comes along
with the springs.

What do I use for shims?
How thick should the shims be?
Do I install a shim on the top, or the bottom, or both?
Does anyone sell them pre-cut?

Any information appreciated.
Thanks
Jeff
83.5 Westy
LA,CA

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.