Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2002, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 27 Jun 2002 11:07:42 -0500
Reply-To:     wilden1@JUNO.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stan Wilder <wilden1@JUNO.COM>
Subject:      Re: Best grease to use for CVs
Comments: To: hradek@yahoo.com
Content-Type: text/plain; charset=us-ascii

Re: Use CV-joint grease -- it's very special (nasty) stuff loaded with lead. LEAD = Graphite Its just plain old vanilla stuff. The only thing you got to worry about is putting in so much that it winds up tearing your CV boots from centrifugal forces at highway speeds. They say 3 oz. Pack the cups in the drive hubs and fill the joint ------- the grease will find its proper point of it isn't too thick.

Stan Wilder

On Thu, 27 Jun 2002 08:42:18 -0700 gary hradek <hradek@YAHOO.COM> writes: > Date: Thu, 27 Jun 2002 08:30:04 -0400 > From: David Beierl <dbeierl@ATTGLOBAL.NET> > Subject: Re: Best grease to use for CVs > > At 08:21 AM 6/27/2002, aerie wrote: > >I want to put in new grease now while I have the > axles out of the > >vehicle. Does anyone know the best grease to use. I > especially do not > >want to degrade the boots by using the wrong lube. > > Use CV-joint grease -- it's very special (nasty) stuff > loaded with lead > and > such. Comes in 90-gm tubes or similar, each one > supposed to be good to > fill one joint. List wisdom is that it's better to > use more than the > specified amount. YMMV. > > david > > David, > I do not think they add lead to the cv grease. > The most important role of the grease is to lubricate. > CV grease is redesigned wheelbearing grease that will > handle the higher temperatures by the addition of > sulfur "I think". The heat is from the disc brakes. > Wheeling bearing grease could handle the heat from the > drum brakes. I think that high temperature grease > does a better job at higher temperatures but make > little difference at lower temperature. I do not > believe that vanagon joints are hot joints unless you > have added disc brakes. So I would say most any auto > grease will work just avoid those saturated animal > fats. Some auto grease on the market sold in England > is considered evironmental friendly but I am sure it > does not make a good fish and chips. > cheers, gary > > > __________________________________________________ > Do You Yahoo!? > Yahoo! - Official partner of 2002 FIFA World Cup > http://fifaworldcup.yahoo.com >

________________________________________________________________ GET INTERNET ACCESS FROM JUNO! Juno offers FREE or PREMIUM Internet access for less! Join Juno today! For your FREE software, visit: http://dl.www.juno.com/get/web/.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.