Well, Got under the Wobbly Bus after work today... here's what I checked. ECU Connector: Jumped pin 3 - 13 No pump action even cranking starter Checked pin 14 - 13 12v only when cranking starter Checked pin 14-19 No v when cranking Current Control Relay / Fuel Pump Relay No audible click from relays No V at pin 87 of Digijet Control Relay (Bentley p97.89 Pin 30 = 12v Pin 86 = 0v (looks like connection from coil, Bentley 97.88) Question: The coil shows this input coming from the #15 voltage source (gray area at top of page) This is ignition switch output, right? I'll probably check that next. But the coil also shows ground point 15 is right there as well... how does that work?
Any help appreciated. Will offer fresh salmon to person with right info...frozen and shipped of course.
Scott De Santi Anchorage, Alaska 86 Vanagon 2WD (Wobbly Bus) 98 New Beetle 2.0 (2Gruvy) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.