VANAGON archives -- July 2002, week 3 (#683)

Date: Sun, 21 Jul 2002 23:20:36 -0400 Reply-To: David Beierl <dbeierl@ATTGLOBAL.NET> Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com> From: David Beierl <dbeierl@ATTGLOBAL.NET> Subject: Re: Fw: Need advice about chuck with stripped threads Comments: To: George Averill <averill@LDL.NET> In-Reply-To: <003601c23126$6eef73e0$57c5c2d1@averill> Content-Type: text/plain; charset="us-ascii"; format=flowed

George, you sent this to vanagon list instead of Atlas-Craftsman... <g>

david (Vanagon, Atlas 618 lathe)

At 10:20 PM 7/21/2002, George Averill wrote: >I finally got a little time to try and use the small Craftsman 109 lathe >only to discover problems in the chuck. I needed to remove the jaws in >order to reverse them. When I removed them, I discovered that the threads >inside the chuck were crumbling and falling apart in little pieces.

Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.