Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2002, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 17 Jul 2002 14:58:53 -0700
Reply-To:     Matthew Pollard <poll7356@UIDAHO.EDU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Matthew Pollard <poll7356@UIDAHO.EDU>
Subject:      Re: WANTED: plastic molding for window switch
Comments: To: marty guinn <meguinn@HOTMAIL.COM>
In-Reply-To:  <F192n9RQAOCop3wyv9k000162b0@hotmail.com>
Content-Type: TEXT/PLAIN; charset=X-UNKNOWN

you can wrap some duct tape around the swith to keep it in place if the little tabs break off... pull the door panal, wrap some duct tape with a small spacer block on the top and bottom of the swithc and shove it back in the door. works.

Matthew Pollard "Racing with the wind and flirting with death Dept. Of Chemistry So have a cup of coffee and catch your breath" University of Idaho www.uidaho.edu/~poll7356

On Tue, 16 Jul 2002, marty guinn wrote:

> Hi again, > > I'm lookin for the plastic molding piece that goes around the right side > power window switch. About 2 inches tall. This piece has a couple little > clips on it that holds the switch into the door siding. This is also the > 'single switch' and not the 'double switch'. > > Does anybody have one to get rid of? > > thanks, marty > 88 westy > > _________________________________________________________________ > Join the world’s largest e-mail service with MSN Hotmail. > http://www.hotmail.com >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.