Another way to control the depth of a drilled hole is to wrap the bit with duct tape at the needed length. Jim developtrust wrote: > INSTALLATION ADVICE? Look in the vanagon.com articles. Be sure to drill in > only 1/4 inch or you will cut the wires in the post. If you do this you will > have to rewire and it will be an almost impossible task, very labor > intensive and a real headache. > > Use a piece of 2 by 4 to stop the drill from going in too far. Good luck. > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.