Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2002, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 29 Jul 2002 14:52:08 EDT
Reply-To:     BenTbtstr8@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Ben T <BenTbtstr8@AOL.COM>
Subject:      Re: swapping middle seat for rear-facing seats
Content-Type: text/plain; charset="US-ASCII"

In a message dated 7/29/02 11:08:50 AM Pacific Daylight Time, BenTbtstr8@AOL.COM writes:

<< More like drill and bolt on. Lots of both. If yu decide to go the factopry route, then it's drill, wled, bolt on.

The factory wleds in the floor locating slots and reinforces and welds where you have to bolt on the back of each front seat. >>

OK so I can't spell check when I just wake up. Fat fingers & foggy brains. Must be very early morning somewhere. Mars maybe.

BenT


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.