Yeah! Every once in awhile something goes right! You may recall that I suspected that my low-speed fan switch was kicking in at too high a temperature. Somewhere just shy of 3/4 on the gauge or as another list member suggested, 2 needle widths past the LED. Others on the list confirmed that their's were coming on at about the same point while still others and my past experience with my '87 seemed to indicate otherwise. Last night I finally did my flush and fill and replaced the switch at the same time. Eureka! Now the fan kicks in just as the needle passes the LED! It also seems to stay on for a shorter period of time probably due to the temperature not being as great and therefore easier for the fan to correct. BONUS! I should also mention that I tried a different approach to my flush and fill which proved quite easy. I used the switch hole in the bottom of the radiator to do the draining. On average I would get about 1.5 - 2 gallons each time I drained it. I left the bleeder screw (bolt) out of the top of the radiator so that it could fill completely without air issues while I refilled with the engine running at the main tank in back. I would refill until it wouldn't take anymore and then wait for the thermostat to open and the radiator to fill up. Then continue to pour it in until it the tank was full. I'd shut off the engine and pull the switch (DANGER! DANGER! DANGER! You can easily scald yourself here if you're not careful and especially if you let the engine get too hot. I used heavy duty elbow length rubber gloves and stood out of the way.) Put the switch back in, start her up and start pouring in the water again. Very simple. I also back washed the radiator a few times to speed things up. After about 4 times, the water was running clear. I then ran a cleaner through the system which then took about another 4 flushes to clean out. Then I started pouring in the distilled water to try and displace as much of the tap water as possible. After two more flushes, I added the coolant and was thrilled that by the time I got done bleeding the system and filling the overflow, I'd used nearly the entire two gallons! Yeah! Another note: I did all of this except for the final bleeding, with the back of the van up on ramps. Not sure if it made a big difference in how much drained out but I'd like to think it did. Jeff Warner Galloway, OH '87 GL Weekender "Van" '86 Wolfsburg Westy Weekender "Barry" CI 94 (including compressors!) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.