Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2002, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 7 Aug 2002 00:39:40 -0400
Reply-To:     Dan Barrett <dan@OFFTHEHILL.ORG>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dan Barrett <dan@OFFTHEHILL.ORG>
Subject:      Re: linkage woes
Comments: To: drillock@EARTHLINK.NET
Content-Type: text/plain; charset="us-ascii"


Mark,
Many thanks for your reply -- my one remaining question has to do with the
flexibility of the two sides of the linkage.  On my bus, I loosen the clamp
and the joint doesn't move front-to-back.  I can swing the whole linkage
side-to-side (when in neutral; this causes the gearshift lever to move left
to right); this makes the front shaft turn in relation to the rear shaft, I
think.  I've been loosening the clamp, swinging the whole assembly left or
right, and tightening back up.  Is this the kind of adjustment I'm after?


Best,
d.
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.