I'm taking my wife's '87 Westy to a traditional, old fashioned alignment shop tomorrow. The tires are wearing on the inside edges. The Bently manual reads: "Measurements for "full load" & "half load" apply for vehicles which cannot be measured unladen because of special equipment installed" and: "Some models from 1986 on, have a lower chassis height. For these vehicles use the "half load" measurements for the "empty" settings. So, what settings should be used for an '87 Vanagon GL Westfalia, air & cruise, water tank empty, only extra being a pull-out awning over the side door? Ron Komoroski |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.