I have my dashboard out (replacing the fresh air fan) and am also doing the master cylinder. The one I had ordered from Van Again in NJ came with 2 brake light switches mounted in cylinder. Problem is tho that my old switches were 2 prong and these new ones are three prong. I've switched the switches :) and the old ones fit fine but I'd rather use the newer ones. Can I just plug the two prong female connector onto two of the three males in the new switches and ignore the third? or did I get the wrong one from Van Again?? Thanks for any help here.
-- Dan Erlandson Flemington, NJ > danoer1@eclipse.net |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.