Didn't look in the Bentley, but I am assuming you are referring to the rear mounting bracket. There are actually three bolts that hold that mount to the engine. @ are M10X85 X 1.5. The third is M10X28(30 will do)X1.5. The original bolts were only grade 8.8. I like to use better to get the better corrosion protection. Dennis
-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Joe Sent: Tuesday, August 20, 2002 9:29 PM To: vanagon@GERRY.VANAGON.COM Subject: 2.1 L engine mount bolts I picked up a used engine from a parts yard. The engine is missing the two bolts on Bently page 13.38 that go through the engine support, labeled 45 Nm (33 ft lb). Does anyone know what size these bolts are and if they are any special grade. Thanks in advance. J.R. Beckham Narragansett Rhode Island 85 Westy 87 Wolfsburg 91 GL |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.