Does this mean that we should tighten the screw until it just touches the valve stem and stop there?
this where reading my article would be helpful When trying to adjust the valves on a rebuilt engine, or when working on an engine that has had the heads or rockers off for a few days or when replacing lifters I have recommended the following. Set the valve lash to .006" (I.e. no pre-load). o lash cold is preloaded hot so just touching is not the same thing preloading is not worth the trouble it causes I dont preload any of my lifters EVER Bob |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.