Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2002, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 27 Aug 2002 21:46:40 -0400
Reply-To:     Robert Donalds <bostneng@FCL-US.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Robert Donalds <bostneng@FCL-US.NET>
Subject:      Re: adjusting Hydraulic Valve lifters
Content-Type: text/plain; charset="iso-8859-1"


Does this mean that we should tighten the screw until it just touches
the valve stem and stop there?




this where reading my article would be helpful


When trying to adjust the valves on a rebuilt engine, or when working on an engine that has had the heads or rockers off for a few days or when replacing lifters I have recommended the following. Set the valve lash to .006" (I.e. no pre-load). 


o lash cold is preloaded hot so just touching is not the same thing preloading is not worth the trouble it causes I dont preload any of my lifters EVER 


Bob
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.