Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2002, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Thu, 29 Aug 2002 10:28:01 -0700
Reply-To:   Bill N <freeholder@STARBAND.NET>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Bill N <freeholder@STARBAND.NET>
Subject:   Re: 84 Westfalia - Front Table Leg
Comments:   To: JOE65@AOL.COM
Content-Type:   text/plain; charset="iso-8859-1"

OK, I measured my '81 Westy tables. The tables I measured are not actually the originals, because I made new ones out of hardwood (much prettier). However, when I made them I was careful to duplicate both the size and the pivot placement, so they are identical to stock in all dimensions.

Front table: 16 1/4 by 24 1/4. Top is 30 3/4 from the floor when mounted. The horizontal arm reach is 10 5/8 from the center of the upright tube to the center of the pivot socket under the table. The center of the pivot socket is 8 1/8 from a long edge and 10 3/4 from a short edge. It is not centered in either direction.

Rear table: 16 1/4 by 32. Top is 28 3/4 from the floor when mounted. The horizontal arm reach is 18 1/4 from the center of the upright tube to the center of the pivot socket under the table. The center of the pivot socket is 6 3/4 from a long edge and 13 3/4 from a short edge. It is not centered in either direction.

I hope this helps.

Bill

----- Original Message ----- From: "Joseph Angrisani" <JOE65@AOL.COM>

> Still trying to figure out this table leg thing (so the correct leg gets > shipped the first time!), and I was wondering if a few of you with both > tables and legs could go out to your early/mid-80's Westy with a tape measure. > > I was wondering if a few of you could send me your table dimensions, their > locations F or R, and the heights off the main floor for both the front and > rear tables. Also, if you could, let me know if the "reach" of the two table > legs are different...a measurement would be nice. I'm trying to determine > if, and how, the two legs are different.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.