Date:         Fri, 30 Aug 2002 16:25:02 -0400
Reply-To:     SStones <sstones@IDIRECT.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         SStones <sstones@IDIRECT.COM>
Subject:      Re: bench seat storage
In-Reply-To:  <5.0.2.1.0.20020830160507.02460950@mail.vt.edu>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 04:11 PM 8/30/02 -0400, Scott wrote:
>No Shit.  I understand that you lift up the seat bottom to access the
>storage area.  My question was about the 2 cutouts on the lower panel and
>if the panel was made to be moved/folded down.  Glad I could humor you,
>"JordanVW."  Thanks for the outstanding input.

If you take the screws out does it remain in place? Does it have the clips
that hold onto the legs of the rear bench like in the non-folding benches?
Are the two cut-outs there just to let air in as the rear heater blows it out?
If, without the screws, it behaves like the non GL seat, then you're
laughing, you just avoid putting the screws back in. But I don't even know
if the fold out seat has the legs like the non-GL.  I'll bet you could tell
by looking. But then again, I'm not providing a whole lot of outstanding
input...
My non-GL panel pops on and off of the seat legs beautifully and I like
it.  It's brown, the corners are chafed from being bumped against things.
Have a good long weekend, folks.