Date:         Fri, 30 Aug 2002 20:57:30 -0400
Reply-To:     Ben huot <huotx@VIDEOTRON.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Ben huot <huotx@VIDEOTRON.CA>
Subject:      Re: Temp II sensor install
Comments: To: John Runberg <jrunberg@MAC.COM>

About the size of a small glass, be prepare!!!! when you remove the old one
to get some in your face (he he he), the O-ring is the problem, put some WD-
40 to help get this one in faster, it will go in easier.

After it's done and your all wet!!! Start the van and open the thermostat
bleeder screw, but this is not a must at all, just open this one as a
precaution.

Have fun, Ben (i did that many time when i was testing 3 new thermostat and
temp sender, at the end i was not even openning the bleeder)
http://www3.sympatico.ca/huotx/engine1.htm

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.