Date:         Sat, 21 Sep 2002 12:25:44 -0600
Reply-To:     s_j_wacker@JUNO.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         s_j_wacker@JUNO.COM
Subject:      Cylinder sleeves, new problem
Comments: To: syncro@yahoogroups.com
Content-Type: text/plain; charset=us-ascii

Thanks Tom F. for your input. After pulling the sleeve out a little
further, we found that the one of the rings was broken. So...we order a
set of rings from BD or Ken, do we need to change all the piston rings
(all four pistons) or can we just change one or two without stressing the
two pistons on the other side. I understand that in order to reach the
wrist pin on the piston we need to pull, requires removing the first
piston. So, change one, two or all?

Thanks


Steve & Jo Ann Wacker
Grand Junction, Co.
90 Carat
86 Syncro
01 Subaru Outback

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.