Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2002, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 23 Sep 2002 13:19:42 -0400
Reply-To:     Kenneth Wilford <kenwilfy@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Kenneth Wilford <kenwilfy@COMCAST.NET>
Subject:      The clutch job from the Nether Regions!
Content-type: text/plain; charset=iso-8859-1

'85 Westy's clutch died the other night at the local gas station. I started it in gear and got her home shifting at the proper rpms with no real problems. At first I thought it was a hydraulic problem since the pedal would go to the floor with no resistance, and there was some wetness at the arm on the side of the tranny right below the clutch slave. Changed the clutch slave and master cylinders(they usually go bad together) and bled the system. Now the pedal would go down halfway and stop like it was hitting something. Pulled the trans and here is what we found: The operating shaft that pushes the throw out bearing against the pressure plate normally has two short arms on it to support and push the TO Bearing. One of these had broken off! The TO Bearing had come off of the remaining arm and was just sitting up against the pressure plate. It seriously messed up the fingers on the pressure plate. I have never seen this before. Today when we are putting everything back together I think I figured out what broke the operating shaft. The TO bearing slides on this metal tube that is around the splined input shaft of the transmission. This metal tube was worn so bad that there was a grove in it and I think this was binding up the TO bearing enough to put a strain on the operating shaft lever arms. Eventually the strain was enough that the arm broke at the weld.

My advice: If you are putting in a new clutch, check this tube that the TO Bearing slides on for wear. If it worn replace it (it is only a $10-$15 part). Hopefully this type of clutch failure will remain rare. Just thought I would share.

Thanks, Ken Wilford John 3:16 http://www.vanagain.com Phone: (856)-327-4936 Fax: (856)-327-2242


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.