Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2002, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 22 Sep 2002 10:56:30 EDT
Reply-To:     THX0001@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         George Goff <THX0001@AOL.COM>
Subject:      Re: Cylinder sleeves, new problem
Content-Type: text/plain; charset="US-ASCII"

In a message dated 9/21/02 3:48:15 PM, kenwilfy@COMCAST.NET writes:

<< If you have alot of patience and a little luck you can use a big hose clamp as a ring compressor tool. Go to Home Depot and try to find one that is at least 3/4" wide >>

If you can find a 3/4" wide hose clamp at Home Dippo, I'll eat it. They may have 9/16" wide hose clamps, but for 5/8" or wider hose clamps, you will have to go to an industrial supply house. A 3/4" wide hose clamp will most likely be of the T-bolt style.

George


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.