Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2002, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 23 Sep 2002 00:05:34 EDT
Reply-To:     THX0001@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         George Goff <THX0001@AOL.COM>
Subject:      Proofing a Heater Core
Content-Type: text/plain; charset="ISO-8859-1"

After a few too many years of Vanagontude, I can't be the only one with an array of heater cores ever at the ready to be pressed into service on a moments notice. Now, the rear heater core poses no real dilemma; if a replacement leaks, pinch off the hoses and try again. But, the front core is a different beast because, as we all know, if it chooses to piss coolant it is a pain to change out.

So what do we do to proof a heater core enough to risk buttoning up the dashboard? Hook up the hoses and run the car until the core is good and hot, then close up everything if no leaks are found? I did that once with a new core from an aftermarket vendor (Hey dude, it's made by the same manufacturer who supplies them to VW. Sure). It must have taken a few thermal cycle to open the crack enough to be palpable, for within a week the core was filling the air with that sweet smell of failure. A little irksome to say the least.

I have two ideas of how to test a front heater core before installation and I would like to elicit any thoughts or experiences, especially experiences, regarding this matter.

1/ Cap off one of the heater core stubs and connect low pressure air set at little more than the coolant system relief pressure to the other. Then, immerse the subject of the test in a tub of boiling water and watch for bubbles.

2/ I have two spare valved taps in my hydronic heating lines at home. The system operates at 180 ºF with about a 30 ft. head. Properly guard the core under test, plumb it to the spare taps and let it run for a week in February.

If anyone says that this is so anal that they want to slap some sense into me, let it be the one who has installed a new front heater core, then has had to rip it out almost immediately in order to replace it with a junkyard jewel. That experience can justify almost any amount of paranoia.

George


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.