I think most of what you describe is due to the weight of the engine being moved to the jack. The rear of the Vanagon is then lighter on the rear suspension and the body creeps up. This is another advantage to using a hoist that bridges the engine hatch opening. The weight of the engine is still carried by the vehicle suspension even when not attached to the engine mounting system. Much easier to get the mounting holes lined up. I attach a chain to the 2 VW provided engine hoist attachment holes and to a third hole I drill into the right side alloy mount arm closer to the rubber mount end. Using these 3 attachment points keeps the off balance 50 degree engine at the proper angle while it is suspended from the hoist. I find this kind of hoist arrangement to be far superior to the jack under the engine method when dealing with inline engines. No worry about the alloy oil pan getting damaged either. Mark David Brodbeck wrote: > My '82 diesel has this setup, too. The bearer bars are on rubber bushings > and then the engine is tied to them with rubber bushings as well. I've > heard the bushings between the bearer bars and the body were omitted in > the '83 model. > > All those rubber bushings can be a pain if you have to remove an engine > mount. (Necessary, for example, to take off the diesel's exhaust > manifold.) You put a jack under the engine to support it and unbolt the > mount -- no problem. But when you go to put it back in, you discover it > doesn't fit! With the weight off the bushings, the bearer bar has raised > itself up. You have to jack the engine up another inch or two to get > everything to fit back together. This caused me a bit of head-scratching. > It's a slightly disturbing moment when you try to put a critical > structural piece in and can't get it to fit back where it's supposed to. > ;) > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.