Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2002, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 5 Oct 2002 19:37:19 +0100
Reply-To:     Clive Smith <clive.harman-smith@NTLWORLD.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Clive Smith <clive.harman-smith@NTLWORLD.COM>
Subject:      Re: Torque Wrench
Comments: To: Marla Stelk <mjstelk@HOTMAIL.COM>
Content-Type: text/plain; charset="iso-8859-1"

No, to do this you don't need a torque wrench. Use the correct size spanner (about 8" for this stype of job) and modicum of sensitivity.

Use yours EYES (to judge the state of the studs/nuts and their size), use EXPERIENCE (and how do you get this without just doing it?) and FEEL (when the torque you're applying stops increasing as the nut or bolt is still continuing to tighten, its time to stop!) and your EYES AGAIN (is the gasket starting to look pretty well compressed).

NEVER tighten just one bolt for long before moving to its counterpart(s) and before you start, ensure all surfaces are true, flat, devoid of detritus, threads are clean (wire brush) and then plenty of COMMONSENSE. Check and tighten 1/4 turn or whatver feels right after a few days and rest easy...

... then start saving pennies for the torque wrench which is mandatory for 50% of jobs and remember, even with a torque wrench things can go wrong - but its a damn good guide - even using one follow the guide above - don't keep turning ad infinitum even if the torque wrench doesn't click - stop and lower the torque a bit if unsure - are you near the correct torque? - instinct is still not to be dismissed - no doubt this is not a new bolt, nut or casting insert - be judicious.

Good luck,

Clive '88 Syncro Transporter

----- Original Message ----- From: "Marla Stelk" <mjstelk@HOTMAIL.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Saturday, October 05, 2002 4:30 PM Subject: Torque Wrench

So just how important is it really to use a torque wrench? A mechanic I spoke to once said he never uses one for tune-ups. But the Bentley tells you to use one for almost everything. I've got to take the top off my thermostat - do I really need to go buy a torque wrench to put it back on? The buggers are pretty expensive.....

Thanks, Marla '87 Westy Van "Morrison"Get more from the Web. FREE MSN Explorer download : http://explorer.msn.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.