At 01:12 PM 10/14/2002, you wrote: >Dok, > >Can you give me an explanation as to why a clicker is not accurate enough. >You mention the long studs, so I assume that some how affects the clicker >wrench. If a clicker wrench is calibrated correctly, why wouldn't it click >at the proper torque? The torque reading on a beam wrench can change just >by moving your head a little. The other issue is the wet sealant under the head nuts. If you use a torque wrench you will see that the flexing of the bolts is much like a torsion bar. It makes it impossible to get a clicker to repeat torque at consistent turn. You can work the beam wrench more and less near proper torque to pull it down to an accurate repeatable position. Mine also incorporates a a "tale-tell" that follows the indicator pin to show the maximum value obtained. Despite all than, don't take my word for it. Listen to the engineers who designed it, they say a beam wrench only for this application because you will get false readings with a clicker. Don't do it their way and you may assume whatever risk that entails. Do it their way and reduce risk. Pick one. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.