Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2002, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 9 Oct 2002 21:24:25 -0500
Reply-To:     Stan Wilder <wilden1@JUNO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stan Wilder <wilden1@JUNO.COM>
Subject:      FS Type IV Engines
Comments: To: wetwesties@yahoogroups.com
Comments: cc: Vintagebus@type2.com
Content-Type: text/plain; charset=us-ascii

For sale: 80-83 Vanagon VW Canada long block engine. This engine has 30,000 on the perfect mains. Zero time on the cam bearings, and Zero time on the standard size rod bearings. The crankshaft is standard on the mains and standard on the rod journals. The oil pump is included. It came to me with #3 cylinder scored. I replaced the cylinders with a good set of Mahle from my stock that had 15K on them and were known to be good when removed. New Brazilian rings were installed in the serviced cylinders. Deck height is set to .028 (should be about 7.4 compression ratio. Crank end play is set to .012 It has two AMC heads (that I bought new) with 30,000 miles on them. This engine comes fully assembled ready for your sheet metal and injectors. You'll also need your engine fan/spacer, oil cooler, fan shroud, oil filter mount, flywheel or flex plate. While it was disassembled I installed a Porsche windage tray and notched the rods. I'd expect this engine to run some cooler than the standard rebuilt engine. Price on this engine with no core charge is $1200.00 + freight ---------------------------- For Sale 80-83 Vanagon engine partial assembly with 5,000 miles on it. This engine came to me with a #3 exhaust valve seat dropped. This engine assembly consist of engine case with standard crank, standard rods, oil pump, stock camshaft, lifters. You'll need your valve train, cylinders, pistons, heads to complete this engine. It comes with a flex plate mounted. Price on this assembly $550.00 + Freight ----------------------------- For Sale 75-79 GE series Type IV Crankcase, bare, standard case bore, accepts 2000 cc, 94mm cylinders $200.00 ----------------------------- Don't let freight from Dallas TX keep you from buying. I'll pay all freight over $100.00 if I can ship by Forward Air and you can pick up at one of their terminals.

Stan Wilder

________________________________________________________________ GET INTERNET ACCESS FROM JUNO! Juno offers FREE or PREMIUM Internet access for less! Join Juno today! For your FREE software, visit: http://dl.www.juno.com/get/web/.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.