In a message dated 10/18/2002 5:00:31 PM Mountain Daylight Time, wilden1@JUNO.COM writes: << Should be on spring pins that just pop out (like the door and read door panel). I use a wide blade putty knife for leverage under the panel. Check for screw heads before you force anything, never know what the PO did. Stan Wilder On Fri, 18 Oct 2002 17:54:38 EDT Patrick Rueb <VW87JETAGL@AOL.COM> writes: > anyone know how to remove the intetior plastic panal piece on a 87 > wolfsburg. > its under the table and if i have to remove folding bed seat what is > involved > with that thanks for the help > peace > patrick > > >> Not at all. you start to pry it out and youll break it. its not held in by clips like the front or sliding door panels. to remove the carat/wolfy plastic sidepanels you must first remove the sofabed, then the table, unscrewing the tabletop from the support bracket, then the bracket itself, then the carpet/ corkboard, to expose the screws at the bottom, unscrew them, then slide panel down and out from under the metal lip at the top..and even this is a condensed version.. basically to remove this panel you have to gut the whole rear part of your van's interior. chris |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.