Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2002, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 16 Oct 2002 09:01:37 -0700
Reply-To:     Matthew Pollard <poll7356@UIDAHO.EDU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Matthew Pollard <poll7356@UIDAHO.EDU>
Organization: www.Shitbag.com
Subject:      Re: ??? Solder Joint Design ???
Comments: To: westydriver <westydriver@TACTICAL-BUS.INFO>
Content-Type: text/plain; charset=us-ascii

yep. silver soldering i do for high vacuum systems first start with a tight fit (aka no gap, but not a press-fit). Properly heating the joint will cause the solder to be drawn into the joint and create a seal. matthew


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.