A common way to increase boost w/o changing the wastegate is to introduce a leak valve between the intake manifold and waste gate. Practically the line is cut and a "y" is put in. A hose and an adjustable valve is put on the third connector. By adjusting the valve, some of the air that would have opened the waste gate is leaked off, and the watse gate will open at a higher pressure. Note that this system is difficult to set right, and requires frequent checking of the boost pressure. Now, by adding an intercooler, you also introduce more air w/o increasing the boost pressure. In the TD fuel pump the fueling is regulated in response to the boost pressure by means of a membrane pressure meter, where a needle goes up and down into the pump internals. The curvature of the needle sets the max fueling for a particular boost. In factury IC equipped cars the needle curve is different from regular TD's and allow higher fueling at high boosts. A cruder solution (avoiding getting an IC fuel pump, or modifying yours) is to just turn up the max load screw. This won't give the optimal fueling, but maybe close enough. /Martin |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.