Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2002, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 7 Nov 2002 12:17:08 -0800
Reply-To:     mark drillock <drillock@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         mark drillock <drillock@EARTHLINK.NET>
Subject:      Re: Fan not working , would this screw it up too ?
Comments: To: Dave Vieira <dave172c@YAHOO.COM>
Content-Type: text/plain; charset=us-ascii

The brown wire is ground. The red wire is for high speed and the remaining wire is low speed. You must have an early watercooled model.

Later models and models with factory A/C have a different fan motor with only 2 places for wires. On these the different speeds are done by an external resister.

Mark

Dave Vieira wrote: > > Question > > My fan is not working, just figured that out now .. > didnt htink they had one .. :) . > > now i donno why its not working checked all the fuses > seem all good.. now i want to test the motor .. now > there are 3 wires off of it.. correct me if im wrong > > red - positive > red with strips - control > brown - ground > > hows that sound > > would this be a part of my cooling , air problem ? > > is there is a leak in any of the hoses would that > bring in air too ? > > and .. i stripped the bleeder bolt is it ok to just > tap a new one and use a new bolt . i dont see why not > but u never know > > and also now ... could it be vacum that is puttin in > air .. cause the engine would rev and and down , up > and down then stall .. i know thats vacum i donno what > one but ill have to figure that one out . but would > that add to the air in the cooling system ? > > and other note to consider, what does this mean .. > when i have the expashion cap on and the engine is > warm but not running i get nothing out from the > bleeder .. now when i took the cap off .. all of a > sudden the bleeder starts apissin ! never tyred this > when the engine is running but .. could this mean > something is wrong with the cap ... not venting of > something . and when the cap is off i loose heat > slowly > > what do yea make of this ... eveything ... crazyness > > im still fishing !! . > > thanks of everyones help so far ! . > > ===== > Dave Vieira > Hamilton, Ontario > Canada > > __________________________________________________ > Do you Yahoo!? > U2 on LAUNCH - Exclusive greatest hits videos > http://launch.yahoo.com/u2


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.