> At the base of the wiper where the arm is attached is a cap. Remove > the cap. Underneath is a nut. Loosen the nut, set the wiper where you > want it, then tighten the nut, re-install the cap. Nothing to it. I'd suggest that while the nut is loosened, take it off and clean out the little teeth in there so that it can get a better grab on the post when re- tighten. M |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.