Date:         Wed, 4 Dec 2002 00:07:36 -0800
Reply-To:     Mark Belanger <belanger@FLUID.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark Belanger <belanger@FLUID.COM>
Organization: Fluid, Inc.
Subject:      Shifter housing...
Content-Type: text/plain; charset=us-ascii; format=flowed

Greetings all,

I'm interested in mounting a couple of drink holders on the AT shifter
housing of my '91.  I suspect most of it is empty, but I wanted to make
sure it was OK to install screws on either side of the housing about mid
height.  The screws shouldn't penetrate much beyond 1/2".


Thanks,
MB
--
_______________________________________________________________________
Mark Belanger - belanger@fluid.com

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.