Happy holidays to all, I'm sending another cry for help. I've almost finished my conversion (thanks to many folks on this list) but still can't quite finish up due to a faulty #3 injector. I managed to pull #1 and #2, but #3 and #4 just won't budge. I've bent my VW special tool, a piece of steel I cut just for the job, and a whole bunch of screwdrivers. Today I took off the valve cover in order to get some more room on it, but although I can get a lot of leverage, still no go. It's been doused more times than I can remember with WD-40 but that hasn't helped either. Does anyone have any advice? Pull the lower insert? Heat it with a blow torch (yes, that's a joke...) Any advice would be appreciated... so close, so very close... Matt ------------------------------------- Matt Ratto Ph.D. Candidate University of California, San Diego mratto@ucsd.edu http://communication.ucsd.edu/mratto -------------------------------------- |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.