Date: Sat, 11 Jan 2003 16:46:24 -0800
Reply-To: gary hradek <hradek@YAHOO.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: gary hradek <hradek@YAHOO.COM>
Subject: rebuilder blames coolant for failure under warranty
Content-Type: text/plain; charset=us-ascii
Matt,
If I had to guess what happened I would say the
heads were not torqued down right? Does not have to
do with the thpe of antifreeze. Either they were
under torqued or warped. Just a guess. I run the
green stuff all the time and am just beginning to see
a problem after about 60k. Thinking about retorquing
the heads to see if it helps. Nothing as bad as your
problem. My sympathy, gary
Date: Fri, 10 Jan 2003 21:21:16 -0800
From: zampano <matthias.k@ATTBI.COM>
Subject: rebuilder blames coolant for failure under
warranty
Hi Vanagonites
I have owned a my Vanagon ('84 WBX Wolfy) for about
three years now,
bought it with 125000 mi on the odo. After 2 years of
intermittent
quirks and failures it overheated last Feb for the
last time and I
decided to get me a rebuild. I opted for a rather
highly recommended
(internet, mail lists etc.) outfit here in SoCal.
I installed the engine myself in late march, along
with all new
peripherals: Radiator, coolant pump, thermostat,
thermo-time switch,
fuel pump, filter, pressure diaphragm, all new
radiator and fuel hoses
(in engine compartment) yada yada. I had done this
before on a rabbit,
an Alfa Romeo and several motorcycles.
I then broke it in (never over 3500 rpms, no load
etc.) for 1500 miles,
changed the oil, had my regular mechanic service it
(mostly just oil
changes, except the replacement of disintegrated
driveaxles), with all
the recommended oil changes.
Anyhow, two weeks ago it started acting up, after not
having any
problem (Except driveaxles) for 10000 miles. The temp
indicator
suddenly rose all the way to the top, stay there for
10 seconds, with
the LED flashing, and then went back down. It did that
for couple more
times the next two days, a very short lasting
occurence. Each time I
checked the coolant, hot and cold, and nothing was
missing. On the 3rd
day I noticed the temp indicator sit on or around the
LED, whereas
before it never climbed past 1/3. I drove the car to
the side
eventually and let it cool down. Then filled it up
with water, bled the
radiator on an incline and still it stayed around or
past the LED. So I
drove home, With the temp gauge LED suddenly,
intermittently flashing,
again for just a short time (seconds), sometimes
accompanied by a
climbing needle. However, during all these incidents
the coolant temp
needle never went all the way to the top, just about
7/10. Also, there
was never any coolant in vaporized or liquid form
escaping from
anywhere. Never.
The bloody head gaskets, I was thinking. Again?? After
such a short
time??
I turned it off at home, checked the coolant, after it
"chilled out" a
bit, and found it nearly filled. I shut the hatch and
called it a day.
The next morning it wouldn't start at all. So I pull
the injectors and
the plugs- a-ok.
I then proceed to do a compression test on all cyls
and, much to my
dismay, I found they all had 0 (ZEEERO) compression.
Valves bent/shot
(new AMC heads from Spain, installed by the rebuilder)
or piston rings
burned up I thought. Darn!! Called AAA, Plus, thank
you, and had it
towed to my mechanic. Outrageous engine failure he
diagnosed, too.
Called AAA again and had it towed 80 miles to the shop
who did the
rebuild.
They pulled the engine and took it completely apart,
including bottom
end. I finally went over there yesterday and took a
look for myself,
though I didn't check the numbers on the case to see
if it was really
mine. Their tech showed me the heads and pointed out
that they were
completely corroded (at the mating surface, where the
gasket goes
between head and block): There was a seam running all
around, when
touched would feel like 3 days of not shaving (The
chin, not my toes).
I was flabbergasted.
I then got into an argument with both the tech and the
shop owner. They
insisted that it was due to improper coolant, and
there being too much
H2O in the mix. I explained to them that the high H2O
content was due
to me filling it with water two days ago, as an
emergency on the road
and that before that I always kept an eye on the
coolant as well as the
rest of the engine. Especially since I was planning on
going to the
mountains over the holidays. I personally filled it
with Prestone
without the phosphate, the orange stuff, not the
green, when I
installed the engine, properly bled the system, never
had any problems,
and 1 month ago ( 2 weeks before final breakdown)
actually checked it
with a coolant tester from Pep Boys, which resulted in
a 50% mix
result. I ended up never going to the mountains.
They both insisted that I should have used the
original VW factory
coolant, went off about electrolysis being the only
proper way to test
it and that my failure in doing so voided the
warranty. The orange
stuff wouldn't do the trick.
At the time, the rebuilder gave me 12 months warranty
or 12000 miles,
detailed on a separate instruction sheet, with all
kinds of
instructions and a inspection sheet on the back of it
for a certified
VW mechanic to check the workmanship of the
installation and overall
condition of the engine compartment and related
accessories upon my
having installed it. My mechanic did this when he
changed the oil after
break in and couldn't find anything wrong. He also did
a tune up
(advanced thereby the timing more than spec, on my
recommendation). He
did the follow up oil changes (every 2500-3000 miles)
also. The Vanagon
never failed me since it got the rebuild. Never got
hot past the LED,
and I think I can count on my two hands the times the
radiator fan came
on. It ran like a champ, getting 16 mpg city and 20
hwy. I was happy.
What gives??? Could something like this really happen
? And is it
really because of me using Prestone instead of VW
phosphate free
coolant?? If so, then screw German engineering, big
time. How come I
could put 24000 miles on the old tired stock engine
with the green
stuff, with her overheating and blowing hoses on a
beserker basis??
If this is so important, then why didn't the rebuilder
point it out, IN
BIG FAT LETTERS that there is no other coolant to be
used except VW's
product, jawohl???
Nein Danke!!
Anyhow, since I hate arguing I stopped, and left the
place telling them
to let me know how much it will cost to fix. I told
them I would be
willing to spend $1000 to get her back together, with
another 12/12000
Warranty. Else, the old girl should perish to WBX
hell. The owners said
they were gonna call me, because it might cost more
since I might need
more parts replaced.
Whatever!! So I left and havent' heard from them. It
seems like that
legally it would be easy for them to get out of ANY
responsibilty based
on me having installed the engine myself. My mechanic
says it is their
fault.
Or am I wrong and this could really happen just
because of the
coolant???
Cheers and Happy Trails
Let me know what you think...
Matt
__________________________________________________
Do you Yahoo!?
Yahoo! Mail Plus - Powerful. Affordable. Sign up now.
http://mailplus.yahoo.com
|