In a message dated 1/9/2003 11:20:41 AM Pacific Standard Time, eunrau@YAHOO.CA writes: << How difficult is it to remove and replace the coolant "T"-Piece? Mine appears to be leaking. Any tips, insight pointers??? >> If you're speaking of the T piece that splits the line to run a hose to your rear heater, it's relativlely straight forward. It's in a slightly awkward position, and goggles are recommended as you'll be lying on your back under the bus with the old dirt falling on you. The Ts in my bus were aluminum I think and weeping a bit. The new VW dealer T--in my bus there are actually 2, I got were plastic and seem to be working fine after several years. The tricky part, as always, is bleeding the coolant system when you refill with coolant. If you haven't done the bleeding of the system before, consult the list again. Best Jeff 83.5 Westy LA,CA |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.