Date:         Fri, 24 Jan 2003 06:13:47 EST
Reply-To:     RAlanen@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Frank Condelli <RAlanen@AOL.COM>
Subject:      Re: front heater problems 85'/Lord have Mercy!
Comments: cc: dbeierl@ATTGLOBAL.NET
Content-Type: text/plain; charset="ISO-8859-1"

In a message dated 1/23/2003 11:11:20 AM Eastern Standard Time, 
LISTSERV@GERRY.VANAGON.COM writes:

> No -- but what Frank's suggesting wouldn't obstruct the flow, just keep it
> from getting to a particular third of a square inch where the end of the
> motor shaft is exposed.  I'm not sure it will help, but pretty sure it
> won't hurt anything if the shaft doesn't get all gummed up with
> adhesive.  That's the one part that I think might make useful sense and not
> likely to cause a problem, assuming it stays put and doesn't get sucked
> through the blower.
> 

       Thanks, David for understanding what I was saying.  Furthermore the 
caps I have used pretty well stay in place by themselves, as they slip over 
the bearing support.  A small amount of silicon sealant holds it there very 
well and it's only common-sense not to get any on the bearing.

Cheers  

Frank Condelli
Almonte, Ontario, Canada
<A HREF="http://members.aol.com/BusFusion/bfhome.htm">BusFusion</A> a VW Camper camping event, Almonte, ON, June 12 ~ 15, 2003
'87 Westy & Lionel Trains
Member: <A HREF="http://www.vanagon.com/">Vanagon List</A>, <A HREF="http://www.bcn.net/~limbo/">LiMBO</A>, <A HREF="http://www.westfalia.qc.ca/">IWCCC</A> & Capital City VW Club 
Vanagon/Vanagon Westfalia Service in the Ottawa Valley
<A HREF="http://members.aol.com/Fkc43/stebro.htm">STEBRO/Vanagon Stainless Steel Mufflers</A>  
<A HREF="http://members.aol.com/Fkc43/busindex.html">Frank Condelli & Associates</A> or http://frankcondelli.com