Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 27 Jan 2003 22:29:51 -0800
Reply-To:     Mike Miller <mwmiller@CWNET.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike Miller <mwmiller@CWNET.COM>
Subject:      Main bearings/rod bearings/bolts
Content-type: text/plain; charset="US-ASCII"

Volks,

Some may remember I got an engine rebuild that refused to seat the rings. Burned about a qt/800 miles. After many miles, 16000, I put in non detergent oil. No change. Someone recommended running it up to 5000 rpm for 10 minutes then letting it cool down slowing a couple of times.

I did this once and the oil usage is 1 at/1500 miles. I'm tempted to try it again but for my concern about rod and main bearings, and I guess rod bolts as it's a 2.1.

Any opinions, or actual facts, about this?

Mike


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.