At 07:36 PM 1/28/2003, Ben McCafferty wrote: >Any of you stereo buffs: I need to determine if my home speakers are 4 or 8 >ohms, so I can set my receiver properly. Unfortunately, there is no marking >on the case or actual speaker anywhere, except "75 watts, magnetically >shielded, design for t.v." Speaker manufacturers tend to make 4-ohm speakers because it's cheaper... If you really want to measure the impedance, you'll need to use a sine-wave test signal of 1000 Hz frequency, and put a non-inductive power resistor in series with the speaker; then measure the ratio of the voltages across the speaker and the resistor; the impedance will be in the same ratio as the voltages, i.e. Zspkr : Zresistor = Vspkr : Vresistor. With a non-inductive resistor Z (impedance) should be the same as R at any reasonable frequency, so multiply that by the ratio. Since the speaker is an inductive* load, impedance will be frequency-dependent, but 1000 Hz should give you the rating number. *actually resistive + inductive and very likely capacitive as well, given the crossover circuits and all. david -- David Beierl - Providence RI USA -- http://pws.prserv.net/synergy/Vanagon/ '84 Westy "Dutiful Passage" '85 GL "Poor Relation" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.