Date: Wed, 29 Jan 2003 06:36:46 -0500
Reply-To: Robert Donalds <bostneng@FCL-US.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Robert Donalds <bostneng@FCL-US.NET>
Subject: Re: Main bearings/rod bearings/bolts
Content-Type: text/plain; charset="iso-8859-1"
Mike and the list
while its not uncommon for new rings to take there time seating I asked myself a couple of questions as I read this thread. First did this rebuild include new pistons and cylinders or just rings. what brand rings ? and did the cylinders get straightened with a ridged honed and measured or did they only have the a light hone to brake the glaze in hopes of the rings sealing. 800 miles to a quart of oil is not a reason to take the engine apart but you need to keep a eye on the oil level.
The idea of revving the engine with no load on it at 5K and holding it there is foolishness even if you had a load on it that's no way to treat an engine.
The clearance of the piston to the cylinder cold is approximately one 1/3 the thickness of a dollar bill and in all my engines I remove the pistons rehone the cylinders and add .001th at least to fit clearance this also gives me a chance check the rings and insure the cylinder is round.
The 2.1 engines originally had a stretch to yield con rod bolts and that is a problem that develops over time not due to the RPM. On my rebuilt engines I use the 1.9 rod bolts when I rebuild the con rods because I fell that is a better bolt over the long run based on the measurements of the countless used 1.9 and 2.1 rods I have inspected.
The fuel mixture if set to rich can dilute the oil and this could increase the oil consumption and prevent the rings from sealing
Bob Donalds
http://www.bostonengine.com
all rights reserved
|
Back to: Top of message | Previous page | Main VANAGON page
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives
@ gerry.vanagon.com
The vanagon mailing list archives are copyright (c)
1994-2011, and may not be reproduced without the
express written permission of the list administrators.
Posting messages to this mailing list grants
a license to the mailing list administrators to reproduce
the message in a compilation, either printed or electronic.
All compilations will be not-for-profit, with any excess
proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively
towards the management and operation of the Vanagon mailing
list and vanagon mailing list web site.